Lab Hydrapulper

Lab Hydrapulper is a complete pulping unit used for marking pulp from secondary fiber waste paper, on lab scale. It can also be used for mechno-chemical pulping. It has 30 liters capacity and can be also made available in 10 & 20 liters capacity, if required. The tub made of stainless steel, is provided with lid to fit tightly on the tub. There is an outer cover on the tub to make an access to the heaters and their connections. Four Heaters of 500 W each are fitted in the double wall annular space of the tub with glass wool as heat insulation to provide the heating controlled through thermostat. The Helicon Turbine fitted inside the tub is driven through V-Belt by the 5 HP motor at 500 RPM, for the desired time duration to form the pulp, at around 80 0C. The pulp samples can be checked by opening the top lid at intervals to ascertain its readiness.

Features :

• Tub made of stainless steel, fitted with top opening, lid and bottom drain valve.
• Available in 10, 20 & 30 Liters capacity.
• Helicon-Turbine fitted inside the tub which is driven by 5 HP motor at 500 RPM with 440 V 3-Phase, 50 Hz supply.
• Special tool made available for fixing and withdrawing of turbine.
• Heaters are provided in the double walled space, heat insulated with glass wool. Temperature is adjustable upto 100 0C and maintained at any value through thermostat control.
• Drain valve provided at bottom for emptying the tank.
• Complete unit with motor and control panel mounted on firm base frame.

Technical Specifications :

• Mains Supply - 415 Volts ±10%, 50 cycles (if not otherwise specified in your order and acknowledge by us)
• Tub Material - Stainless Steel
• Tub Capacity - 30 liters (other capacity of 10 & 20 also available)
• Motor - 5 HP, 920 RPM
• Heaters - 500 W each
• Thermostat control  - Upto 100⁰C